Posted by: Dale "Head_Hunters" DuPont on May 30, 2003 at 12:31:33

That is what keeps your valve body from blowing out when you pressurize your marker. The set screw is cone shaped on the inside to center and locate your valve body port in proper alignment with the hole going to your firing chamber. Now IF that is a standard thread, (most of Kingmans products are metric threads) one could ponder buying a set screw that is too long and grinding the taper you need for the inside and have the overall length what you need to take up your excess trigger travel when it is seated down firmly onto the valve body. A nylon one would work and be easier to file or grind. Just thought about this. Haven't tried it yet. Fair warning..... Or just cut a piece of round stock that would fit into the hole and take up the space you need. Just have to use a piece of scotch tape to hold it in place to put the grip frame back on... Don't have to remove the tape. Just leave it. Let me know IF any of this works. You become the trigger mod expert for Warpig.

Follow Ups: Re: There is supposed to be a set screw in that hole.. Jon "Jonwes" West 12:51:56 05/30/03 (0) Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : That is what keeps your valve body from blowing out when you pressurize your marker. : The set screw is cone shaped on the inside to center and locate your valve body port in proper alignment with the hole going to your firing chamber. : Now IF that is a standard thread, (most of Kingmans products are metric threads) one could ponder buying a set screw that is too long and grinding the taper you need for the inside and have the overall length what you need to take up your excess trigger travel when it is seated down firmly onto the valve body. A nylon one would work and be easier to file or grind. : Just thought about this. Haven't tried it yet. : Fair warning..... : Or just cut a piece of round stock that would fit into the hole and take up the space you need. Just have to use a piece of scotch tape to hold it in place to put the grip frame back on... Don't have to remove the tape. Just leave it. : Let me know IF any of this works. : You become the trigger mod expert for Warpig. [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Spyder ]