|
|
|
Posted by Steve "B-Ski" Biedrzycki on October 13, 2002 at 19:18:52:
In Reply to: tip for e-99 users posted by
: if you slighty modify the neck on a VL200 you can fit the hopper right onto the vertical feed and greatly lower your profile like how? are you separating the neck along the seams and just liding the feed tube in the neck? That does give you a lower profile, but with a marker like that, it's better to have as many balls stacked in the feed tube as possible. Paint chopping becomes a problem the lower the rise.
NuthyN
20:28:28 10/13/02
(0)