|
|
|
Posted by Javin on August 27, 2002 at 01:48:59:
In Reply to: Re: Shorter Trigger Pull posted by
: : I just recently did a trigger job on my frame. I was just wondering where exactly do u measure when measuring the trigger pull. I made the pull as short as i could, allowing the gun to recock. However...i can't get it anywhere near 1/8" pull like Hellrazor does. Any suggestions? Hellrazor help! =P Welp...I'm out...peace : The way he does it is that you have to take the front sear pin out, and cut off a sliver of macroline. Measure the inside width of where the sear sits, then cut that length of macroline just a hair shorter. Then take a pair of needle nose pliers, and put the macroline lined up with the front sear rest, then put the pin in. He had to explain it to me like 15 times, and i still don't understand, so you might aswell try and get him to do it. Or just get an elect. frame like me. =). HTH. Later. heh...i get it until the part where i'm supposed to use needle nose pliers...where do i put piece of macroline? does it go around, on top, or on front of the pin? does anyone really use this spell check? thanks...peace =P
shadow_walker
15:16:15 08/27/02
(5)
Javin
16:51:55 08/27/02
(4)
Justin "Snow_God" Allen
18:12:45 08/27/02
(3)
Javin
02:37:54 08/28/02
(2)
Justin "Snow_God" Allen
21:43:05 08/28/02
(1)
Javin
22:09:55 08/28/02
(0)