Posted by: BodyByHostess on June 26, 2003 at 09:51:49

There are 2 ways I know of to make velocity adjustments easier. Each can be had for about $70 at www.compulsivepaintball.com One, is similar to what you mention. If you use an AKA Tornado valve, AKA recommends using the input pressure to adjust velocity rather than the IVG! This is because the Tornado valve is designed to be fully open on each cycle and is closed primarily by air pressure rather than the valve spring. With the Tornado valve, adjusting the IVG has minimal effect as operating pressure is the key with this valve. (The only other valve that is designed to be fully open is the Maddman Rocket valve, but the Rocket is a bit harder to install and set up) The other solution is the Belsales Rex hammer kit. This kit comes with the hammer and a velocity adjuster that is adjusted without removing the cocking rod. The adjuster has a hex hole off to one side that is accessable when the back block is back (hold the trigger), or with the back block forward (requires a hole to be drilled in the block) Hope this helps! Good luck :)

Follow Ups: Another solution, much cheaper but similar Razorpb 18:53:15 06/27/03 (0) Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : There are 2 ways I know of to make velocity adjustments easier. Each can be had for about $70 at www.compulsivepaintball.com : One, is similar to what you mention. If you use an AKA Tornado valve, AKA recommends using the input pressure to adjust velocity rather than the IVG! This is because the Tornado valve is designed to be fully open on each cycle and is closed primarily by air pressure rather than the valve spring. With the Tornado valve, adjusting the IVG has minimal effect as operating pressure is the key with this valve. (The only other valve that is designed to be fully open is the Maddman Rocket valve, but the Rocket is a bit harder to install and set up) : The other solution is the Belsales Rex hammer kit. This kit comes with the hammer and a velocity adjuster that is adjusted without removing the cocking rod. The adjuster has a hex hole off to one side that is accessable when the back block is back (hold the trigger), or with the back block forward (requires a hole to be drilled in the block) : Hope this helps! : Good luck :) [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Autococker / Minicocker ]