Posted by: Sinagent on November 07, 2002 at 01:28:37

: I've been using mine for almost 2 years now with no problems other than wear (due due milling). I've run as low as 250 psi without flow problems or shootdown. It will work on any 2000+ stock cocker, or any pre 2000 with the use of a 2000+ back block. : Razor : : : is the ANS quick pull bolt good? im considering getting it because the design on the face is supposed to break up air more evenly and put a softer punch on the ball. the main reason for the question is, the site i purchace on says it "will only work on 2000 cockers". not 2000+. but arent the bolt shafts the same. the site is : : http://www.actionvillage.com/011-9010-850-5.html what valve do you use?

Follow Ups: Re: hey razor Razorpb 12:52:14 11/07/02 (1) Re: hey razor Sinagent 21:37:15 11/10/02 (0) Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : : I've been using mine for almost 2 years now with no problems other than wear (due due milling). I've run as low as 250 psi without flow problems or shootdown. It will work on any 2000+ stock cocker, or any pre 2000 with the use of a 2000+ back block. : : Razor : : : : : is the ANS quick pull bolt good? im considering getting it because the design on the face is supposed to break up air more evenly and put a softer punch on the ball. the main reason for the question is, the site i purchace on says it "will only work on 2000 cockers". not 2000+. but arent the bolt shafts the same. the site is : : : http://www.actionvillage.com/011-9010-850-5.html : what valve do you use? [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Autococker / Minicocker ]