![]() ![]() |
|
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
|
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
Posted by elamenopee on October 25, 2002 at 17:47:21:
In Reply to: Re: Bolt Question posted by
: Tighten down you cocking rod in the marker and use a wrench like Vampyr said, loosen the set screw, and then back the nut off a little and cock the bolt back and see where that leaves it, can you see the tip of the bolt? If so it's not far enough, keep going but don't go further than about 1mm back from the feed tube. Then using the wrench to hold it again and tighten the set screw, and your done. Hope it helps. : Razor on mine, the bolt shows when i cock the back block at resting position, but when gassed up, it moves all the way back, until the bolt clears the breech. Somebody explain to me if im wrong, but wouldnt it be less of a shortstroke possibility if the cocking rod is shorter, because it would be cocked sooner in the back stroke in case of a shortstroke? when set like you guys suggest, it cocks at the very last portion of the backstroke, thereby increasing the chance of missing the lug? please tell me if im wrong, i need to adjust it ifi am.
jeff
Razorpb
18:53:48 10/25/02
(4)
Vampyr
22:59:42 10/25/02
(3)
Razorpb
00:16:48 10/26/02
(2)
Razorpb
14:09:34 10/26/02
(1)
Razorpb
14:26:15 10/26/02
(0)