|
|
|
Posted by Superannuated on September 13, 2001 at 22:01:23:
Sam: I have a Bushy (serial # in the 0250 range) that was vaporized by Joe Winters and has the Chaos chip (V2.3, I think) with anti-chop eye. My problem is that the gun intermittently won't fire. It's not the eye itself (I recently replaced it with a new duplicate), and the blue light blinks appropriately when I pull the trigger, so the trigger switch seems to be OK. It's just that some times it shoots and some time not. I had a fellow Bushy owner/friend check the circuitry (he works in electronics) and he couldn't find the problem. I haven't been getting responses from DC Paintball. Is something going on there? I have been using my backup gun for tournaments for the past couple of months , but want my #1 gun up and working. I am good with the gun mechanically, but not as good electronically; if you have any "try this" hints, I would attempt them. If not, could I send it to you for repair? Regards, Superannuated
Daniel "trixx75" Woo
18:31:44 06/14/02
(0)
Subject:Message:
Copyright © 1992-2019
Corinthian Media Services. WARPIG's webmasters can be reached through our feedback form. All articles and images are copyrighted and may not be redistributed without the written permission of their original creators and Corinthian Media Services. The WARPIG paintball page is a collection of information and pointers to sources from around the internet and other locations. As such, Corinthian Media Services makes no claims to the trustworthiness or reliability of said information. The information contained in, and referenced by WARPIG, should not be used as a substitute for safety information from trained professionals in the paintball industry. |